VM-1 Application Board 3
5811
VM-1 Application Board 3 (Issue A) Data Sheet
Introduction
The 5811 is an application board for use with the VM-1 Control Module. It provides connections for modules
such as the 5809 QVGA display interface and 5810 ethernet controller. To support the QVGA the board has
connectors for both display and touch screen. The board also has an RS232 serial port, an optional second
serial port, an I2C connector on Bus 1, and an on-board EEPROM for non-volatile data storage. Additionally
all the digital and analogue channels on the VM-1 connector are available.
This document applies only to Issue A of the board. Issue B has extensive extra capabilities and a slightly
different layout and is better suited to QVGA use.
Unpacking
You should have:
• 5811 Application Board. This document applies to Issue A of the board only.
• Power Connector
• These Instructions
WARNING: Users of Micro-Robotics Control Equipment should be aware of the possibility of a system failure, and must consider the
implications of such failure. Micro-Robotics Ltd. can accept no responsibility for loss, injury, or damage resulting from the failure of our
equipment. Use of our products in applications where their failure to perform as specified could result in injury or death is expressly
forbidden.
© 2004 Micro-Robotics Ltd tel: +44 (0) 1223 523100
The Old Maltings fax: +44 (0) 1223 524242
135 Ditton Walk sales@microrobotics.co.uk
Cambridge www.microrobotics.co.uk
CB5 8QB
Doc 44306 V20041130 VM-1 Application Board 3 (Issue A) Page 1 of 11
QVGA
display
connectors
Touch screen
connectors
I2C
152mm
164mm
101
mm
113
mm
4 x
3.5mm
Serial
Port 2
GN
D
Vo
ut
nc Vin
Serial
Port 1
Location of
Ethernet
module
Location
of QVGA
module
VEE adjust
Contrast
control
Location
of VM-1
controller
Power