Publication# 11559 Rev: H Amendment/+2
Issue Date: January 1998
with in-circuit electrical erasure and programming. The
Am28F010 uses a command register to manage this
functionality, while maintaining a JEDEC Flash Stan-
dard 32-pin pinout. The command register allows for
100% TTL level control inputs and fixed power supply
levels during erase and programming, while maintain-
ing maximum EPROM compatibility.
programming algorithm. The typical room temperature
programming time of the Am28F010 is two seconds.
The entire chip is bulk erased using 10 ms erase pulses
according to AMD’s Flasherase alrogithm. Typical era-
sure at room temperature is accomplished in less than
one second. The windowed package and the 15–20
FINAL
Am28F010
1 Megabit (128 K x 8-Bit)
CMOS 12.0 Volt, Bulk Erase Flash Memory
DISTINCTIVE CHARACTERISTICS
a73 High performance
— 70 ns maximum access time
a73 CMOS Low power consumption
— 30 mA maximum active current
— 100 µA maximum standby current
— No data retention power consumption
a73 Compatible with JEDEC-standard byte-wide
32-Pin EPROM pinouts
— 32-pin PDIP
— 32-pin PLCC
— 32-pin TSOP
a73 10,000 write/erase cycles minimum
a73 Write and erase voltage 12.0 V ±5%
a73 Latch-up protected to 100 mA
from –1 V to V
CC
+1 V
a73 Flasherase™

Electrical Bulk Chip-Erase
— One second typical chip-erase
a73 Flashrite™ Programming
— 10 µs typical byte-program
— Two seconds typical chip program
a73 Command register architecture for
microprocessor/microcontroller compatible
write interface
a73 On-chip address and data latches
a73 Advanced CMOS flash memory technology
— Low cost single transistor memory cell
a73 Automatic write/erase pulse stop timer
GENERAL DESCRIPTION
The Am28F010 is a 1 Megabit Flash memory orga-
nized as 128 Kbytes of 8 bits each. AMD’s Flash mem-
ories offer the most cost-effective and reliable read/
write non-volatile random access memory. The
Am28F010 is packaged in 32-pin PDIP, PLCC, and
TSOP versions. It is designed to be reprogrammed
and erased in-system or in standard EPROM pro-
grammers. The Am28F010 is erased when shipped
from the factory.
The standard Am28F010 offers access times as fast as
70 ns, allowing operation of high-speed microproces-
sors without wait states. To eliminate bus contention,
the Am28F010 has separate chip enable (CE#) and
output enable (OE#) controls.
AMD’s Flash memories augment EPROM functionality
AMD’s Flash technology reliably stores memory con-
tents even after 10,000 erase and program cycles. The
AMD cell is designed to optimize the erase and pro-
gramming mechanisms. In addition, the combination of
advanced tunnel oxide processing and low internal
electric fields for erase and programming operations
produces reliable cycling. The Am28F010 uses a
12.0V±5% V
PP
high voltage input to perform the
Flasherase

and Flashrite

algorithms.
The highest degree of latch-up protection is achieved
with AMD’s proprietary non-epi process. Latch-up pro-
tection is provided for stresses up to 100 milliamps on
address and data pins from –1 V to V
CC
+1 V.
The Am28F010 is byte programmable using 10 ms pro-
gramming pulses in accordance with AMD’s Flashrite