1/3
L5510
December 2004
This is preliminary information on a new product now in development. Details are subject to change without notice.
1 ATA Host Interface Block
■ Synchronous DMA (modes 0-4)
■ Fast IDE PIO modes 0-4
■ ATA Multiword DMA modes 0-2; supports 60 ns
cycle time
■ Basic level of ATAPI support
■ IORDY for PIO flow control
■ Automatic ATA R/W command execution
■ Automatic ATA task file updates
■ 128-byte host FIFO to/from buffer
■ LBA or CHS TASK File Modes
■ Read/write cache support with interrupt
suppression
■ Programmable IRQ automation for different
BIOS implementations
■ Provides logic for daisy chaining two embedded
disk drive controllers
■ Full BIOS compatibility
■ On-chip selectable 4/8/12 mA host drivers
2DSP Core
■ 60 MIPS operation
■ 16-bit, fixed-point DSP
■ 16x16-bit, 2’s complement parallel multiplier
with 32-bit product
■ Single-cycle multiply and accumulate
■ 36-bit ALU with two 36-bit accumulators
■ Bit manipulation unit with 2 additional
accumulators
■ 6 K words on-chip RAM
3 Buffer Controller Block
■ 16-bit wide buffer data bus
■ 16 Mbit x 16 SDRAM support; up to 150 Mbyte/
s buffer bandwidth
■ Automated Data Flow Management (ADFM)
automates disk/host transfers
■ Dynamic segment size switching
■ Auto-Write cache support
■ Automatic servo split address adjustment
■ Disk LBA counter
4 EDAC Block
■ Optimized ECC with up to six burst on-the-fly
(OTF) correction
■ Programmable 480-bit Reed-Solomon code
■ Programmable 3-, 4-, or 5-way interleaving with
6 to 12 8-bit symbols per interleave
■ Optional 3 or 5 byte CRC support
■ Guarantee up to 233-bit single burst or six 33-bit
bursts OTF correction in <3 sector time
■ ECC seeding validating servo and head track
position
■ AIC-8381 polynomial support for backward
compatibility
5 Disk Controller Block
■ Enhanced Headerless Architecture (EDSA)
■ Up to 450 Mbits/s data rate, byte-wide NRZ
■ 31 x 3 byte flexible high-speed RAM- based
sequencer
■ Defect skipping and/or embedded servo
capabilities with Constant Density Recording
(CDR)
■ 128-byte disk FIFO to/from buffer
■ Disk error condition summary bit added to
reduce error detection time
■ Three-index timer
■ MR and PRML channel support
6Servo Block
■ Automatic internal sector mark generation
■ Programmable servo burst sequencer
■ Programmable servo timing mark sequencer
■ Flexible gating and control generation
■ User programmable control output pins
■ Allows servo format flexibility
■ Synchronous servo support
DATA BRIEF
HIGHLY INTEGRATED, AUTOMATED SINGLE-CHIP
DRIVE MANAGER AND DISK DRIVE CONTROLLER
REV. 1
Figure 1. Package
Table 1. Order Codes
Part Number Package
L5510 TFBGA240
AIC-5465-DIE DIE
TFBGA240
DIE